Light and extra large vehicles
Heavy goods vehicles
Capelec side slip plates allow the measurement of the skidding of the front and rear wheels of a vehicle, and the control of possible trajectory deviations.
Recessed at ground level associated with a control chain, it brings out the alignment or the dynamic divergence of the vehicle.
Side slip tester
Dimensions :
45 x 52 x 7 cm
Frame :
galvanised steel
Measuring Range :
20/-20m/Km
Maximum axle load :
4 tons
Power spply :
230/400V, 50Hz
Periodical technical inspection
Side slip tester
Testing of axle geometry conformity
Car repair shops & workshops
Side slip tester
Checking of front and rear axle geometry of vehicle
Manufacturers & Industries
Side slip tester
Measure slippage of front and rear wheels
Capelec supports you in implementing your center and provides you with fully equipped test lanes: gas analyser and smoke meter, EOBD readers, tachometer, brake testers, and headlamp beamsetters.
Design
Innovation Evolutions Adaptation
Manufacturing
Since 1989
Supply
An approved network at your disposal
